Challenging working conditions
Underwater welding is used for workpieces located below the water surface and cannot easily be moved to land due to their size or location. Underwater welding is mainly repair welding, and it is divided into wet welding and dry welding.
Wet welding is always performed as stick welding. The welder works under the surface wearing diving equipment, the welding spot being in direct contact with the water. In addition to a compact and portable stick welding machine, wet welding requires an insulated electrode holder to avoid electric shocks and special varnished welding sticks. The stick must not get wet before meeting the arc. The small size of the electrode holder is an advantage because the welding positions are often challenging, and the space is limited.
If the quality requirements of the weld are particularly high and the work is extensive, underwater welding can also be carried out as dry welding. In dry welding, the underwater welding spot is isolated from water with a special sealable dry space or chamber. The dry space is drained of water, filled with gas, and welding is performed inside the ship to be repaired. With dry welding, the weld’s quality characteristics can reach the same level as when welding on land.
Underwater welding is significantly slower than welding on land; a routine task that can be done in fifteen minutes on land can take up to an hour underwater. This is primarily due to poor visibility - working underwater requires significantly more precision. Therefore, dry welding is often preferred if the conditions and the task allow it. In wet welding, depth limits also come into play; underwater welding can be done at a depth of up to 30 m, but in reality, one rarely dives deeper than 10 m. At depths over 10 m, the diving time limits rising from higher water pressure make the work exceptionally challenging. There is always only one welder underwater at a time, and the work is done in one dive whenever possible. Depending on the task, the welder can take a break, and the other will continue.
Water properties also matter; in cold waters, the welder must dress more warmly. The salinity of the water, on the other hand, affects the flow of electricity; the saltier the water, the lower the current can be adjusted. The welder must therefore know his work environment.
Always prepared – good service is the key
DG-Diving Group is known in the industry for its flexibility and good customer service. The telephone emergency service works around the clock, and the repair team must be on the way to the destination within two hours after the call - the time is precisely defined in the annual contracts. Good service is the cornerstone of the company's operations; they are trusted and have repeatedly proven themselves worthy of that trust.
”Good and reliable service is what we offer. We say things as they are, and get the work done as agreed. That is the core of our work”, said the company founder Mauri Kalliomäki.
The company has a wide range of equipment; 12 fully equipped vans are waiting in the garage in Turku, always ready for a new task. In addition, DG-Diving Group has a lot of different equipment for measuring, cleaning, or repairing work. Most of this equipment is of the company's production and patented. When the work takes place in Europe, the team usually drives to the destination with all the equipment; for more distant destinations, diving equipment is rented, and the company’s tools are sent to the site. Although the team is experienced, the tasks often surprise.
"Nearly every time, we have to apply our knowledge and develop new ways of working. Although we thoroughly think in advance how to best perform the task, the final assessment is only made on the spot, task-specific", said diving supervisor Simon Randström.